Voltage Sensitivity Studies

Faults often cause low voltages that might affect equipment operation. To perform a voltage sensitivity study, first select the One-Line Output tab of the Short Circuit Options dialog box. To open this dialog box, click Short Circuit > SC Options. Select the High Voltage Remote Buses check box, the Low Voltage Remote Buses check box, or both. Then, fault a bus on the one-line. Buses that are highlighted in red indicate voltages lower than the defined threshold limit. If you choose only High Voltage, buses under 1000 volts are not highlighted.

Note: Voltage sensitivity results are only available on the one-line after a fault operation on a single bus.

You can obtain a tabulated bus and voltage list for each fault by selecting the Voltage Sensitivity check box in the Text Output tab of the Short Circuit Options dialog box.

More Information

Short Circuit Reference (IEC)  
Short Circuit Options (IEC)  
     

www.easypower.com

EasyPower LLC

7730 SW Mohawk St.

Tualatin, OR 97062

(503)655-5059

techsupport@easypower.com

feedback@easypower.com

EasyPower knowledge base

EasyPower Version 10.2

Copyright © 2019 EasyPower LLC. All Rights Reserved.

Help was last updated on 3/22/2019