Plotting Items in MCCs and Panels

You can plot the following items in a motor control center:

  • Incoming cable and protective device (breaker or fuse).
  • Load type specified as Motor w TCC: you can plot the motor, cable and feeder breaker.
  • Load type specified as Load w TCC: you can plot the cable and feeder breaker.
  • Feeder cable and breaker/fuse for feed to sub-MCC or sub-panel.

You can plot the following items in a panel:

  • Incoming cable and protective device (breaker or fuse).
  • Feeder cable and breaker/fuse for feed to sub-panel.

You can disable plotting individual items inside the MCC by clearing the Plot Item check box in the data dialog for these items.

More Information

Coordination with PowerProtectorâ„¢  
Plotting Motor Starting Curve on TCC  
Plotting a TCC Curve from a One-Line  
     

www.easypower.com

EasyPower LLC

7730 SW Mohawk St.

Tualatin, OR 97062

(503)655-5059

techsupport@easypower.com

feedback@easypower.com

EasyPower knowledge base

EasyPower Version 10.2

Copyright © 2019 EasyPower LLC. All Rights Reserved.

Help was last updated on 3/22/2019