Coordination in the ribbon. Select the devices for which you would like to plot TCC curves by doing one of the following: To plot a Time Current Characteristic (TCC) Curve from a one-line diagram, you must first enter the Coordination focus by clicking Coordination in the ribbon. Select the devices for which you would like to plot TCC curves by doing one of the following:
After selecting the items, click 
Plot TCC. This causes the TCC curve of the selected items to appear next to a one-line diagram of the selected items. If there is not sufficient data to plot an item, the following message appears:
Figure 1: Items Not Fully Specified Message
Click Yes to produce a report informing you of areas not specified for the items that coordination is unable to plot and the data that is missing. If you click No, EasyPower does not plot the TCC Curve for that item. If more than one item is selected to plot TCC curves, then only the items not fully specified are eliminated from the plot.
Figure 2: Error Report for Unspecified Data
If all data is entered correctly, then Coordination plots TCC Curves for all items selected as shown below.
Figure 3: Coordination Plot of TCC Curves
| Coordination with PowerProtector™ | |
| Plotting Motor Starting Curve on TCC | |
| Plotting Items in MCCs and Panels |
|