Plotting a TCC Curve from a One-Line

To plot a Time Current Characteristic (TCC) curve from a one-line diagram, you must first enter the Coordination focus by clicking Coordination on the Home tab. Select the devices for which you would like to plot TCC curves by doing one of the following:

After selecting the items, click Plot TCC. This causes the TCC curve of the selected items to appear next to a one-line diagram of the selected items. If there is not sufficient data to plot an item, the following message appears:

Figure 1: Items Not Fully Specified Message

Click Yes to produce a report informing you of areas not specified for the items that coordination is unable to plot and the data that is missing. If you click No, EasyPower does not plot the TCC curve for that item. If more than one item is selected to plot TCC curves, then only the items not fully specified are eliminated from the plot.

Figure 2: Error Report for Unspecified Data

If all data is entered correctly, then EasyPower plots TCC curves for all items selected as shown below.

Figure 3: Coordination Plot of TCC Curves

More Information

Coordination with PowerProtectorâ„¢  
Plotting Motor Starting Curve on TCC  
Plotting Items in MCCs and Panels  
     

www.easypower.com

EasyPower, LLC

7730 SW Mohawk St.

Tualatin, OR 97062

(503)655-5059

techsupport@easypower.com

feedback@easypower.com

EasyPower knowledge base

EasyPower Version 9.8

Copyright © 2017 EasyPower, LLC. All Rights Reserved.

Help was last updated on 7/10/2017