Current Flow

Clicking Single Point Current Flow or All Source Current Flow in the Harmonics tab displays equipment currents and bus voltages.

Performing a Current Flow

  1. In the Harmonics focus, select Harmonics Options. On the Control tab, in the Harmonic Current Flow section, enter the current flow frequency to be injected. Select the Text Output tab and select any output text reports. Click OK.
  2. Select the bus for source current injection.
  3. Click Single Point Current Flow and EasyPower displays the bus voltages throughout the system, in either kV or per-unit.
  4. Note: You can set the kV type display on the One-line Output tab of the Harmonic Options dialog box.

  5. Select All Source Current Flow and EasyPower injects harmonic currents at the specified frequency for every harmonic source in the system that contains that frequency in its harmonic spectrum. These currents are injected at the magnitude and angle specified in the Harmonics tab of the source equipment item. Buses do not need to be selected prior to solving. The output is kV or per-unit, as selected.

More Information

Harmonics with Spectrumâ„¢  
Tutorial - Harmonics Analysis  
     

www.easypower.com

EasyPower, LLC

7730 SW Mohawk St.

Tualatin, OR 97062

(503)655-5059

techsupport@easypower.com

feedback@easypower.com

EasyPower knowledge base

EasyPower Version 10.0

Copyright © 2018 EasyPower, LLC. All Rights Reserved.

Help was last updated on 5/22/2018