Arc Flash Hazard Analysis in Coordination Focus

You can perform arc flash hazard analysis in the Coordination focus by selecting the desired bus to fault and clicking Arc Flash. For this application, you must have the arc flash hazard feature enabled in your software. See Arc Flash Hazard Analysis for more information.

Note: Arc flash hazard analysis is not available for IEC.

Next: Tick Marks

More Information

	www.easypower.com EasyPower, LLC 7730 SW Mohawk St. Tualatin, OR 97062 (503)655-5059	techsupport@easypower.com feedback@easypower.com EasyPower knowledge base EasyPower Version 10.0 Copyright © 2018 EasyPower, LLC. All Rights Reserved. Help was last updated on 5/22/2018