Auto Coordination Process
When using auto coordination to coordinate your complete model, it is best to start at the downstream devices, and then work upstream, so all dependent devices are coordinated properly. Using this process, you do not need to re-coordinate a device that has already been coordinated. The figure below shows a typical method of steps for auto coordination. It shows three groups of items to coordinate. Begin by auto coordinating the items in the circle on the bottom left of the one-line. Read through the Auto Coordination Report and verify all protective device settings are coordinated to meet your standards. Repeat this process for the group of items on the lower right side of the one-line. At this point, the lower portion of the one-line is properly coordinated. It is now time to auto coordinate the relay in the circle at the top of the one-line, since all dependent protective devices are properly coordinated. Again, read through the Auto Coordination Report to observe the comments.
Figure 1: Order of Auto Coordination
