Plotting Items in MCCs and Panels

You can plot the following items in a motor control center:

• Incoming cable and protective device (breaker or fuse).
• Load type specified as Motor w TCC: you can plot the motor, cable and feeder breaker.
• Load type specified as Load w TCC: you can plot the cable and feeder breaker.
• Feeder cable and breaker/fuse for feed to sub-MCC or sub-panel.

You can plot the following items in a panel:

• Incoming cable and protective device (breaker or fuse).
• Feeder cable and breaker/fuse for feed to sub-panel.

You can disable plotting individual items inside the MCC by clearing the Plot Item check box in the data dialog for these items.

More Information

	www.easypower.com EasyPower, LLC 7730 SW Mohawk St. Tualatin, OR 97062 (503)655-5059	techsupport@easypower.com feedback@easypower.com EasyPower knowledge base EasyPower Version 9.8 Copyright © 2017 EasyPower, LLC. All Rights Reserved. Help was last updated on 7/10/2017