Entering Dynamic Stability Data

The following equipment require dynamic stability data entered if their response is to be simulated.

Motor

The Stability tab of the Motor Data dialog needs to be enabled and the motor model spreadsheet needs to be filled out. You can import typical data from the library. The running load and starting load data are modeled in the same tab. Based on motor torque-speed characteristics, you can derive motor model parameters using the tool Define Induction Motor Parameters. For details on induction motor parameter derivation, see Motor Data.

Generator

You can enter dynamic stability data for a generator, its governor and its exciter in the Stability 1 tab. Stability 2 is for power system stabilizer data.

Contactor

You can enter the dropout voltage and the dropout delay time for the contactor for fused contactors or breaker-contactor combinations. The data is specified in the Fused Switch Data or LV Breaker Data dialog boxes.

ATS

You can specify the data required for ATS transfer action in Stability tab of the ATS Data dialog box.

Transformer

The transformer inrush current can be modeled in the Stability tab of the Transformer Data dialog box.

More Information

Dynamic Stability Low Voltage Breaker Data
Motor Data ATS Data
Generator Data Three Winding Transformer Data
Fused Switch Data Two Winding Transformer Data
     

www.easypower.com

EasyPower, LLC

7730 SW Mohawk St.

Tualatin, OR 97062

(503)655-5059

techsupport@easypower.com

feedback@easypower.com

EasyPower knowledge base

EasyPower Version 9.8

Copyright © 2017 EasyPower, LLC. All Rights Reserved.

Help was last updated on 7/10/2017