Line End Fault

A line end fault occurs when the end of a line is open or separated from its bus. This is not a standard bus fault. Current flows directly to the end of the line without any contributions from the bus to which the end of the line is connected.

Line End Fault Procedure

To perform a line end fault of a branch/feeder:

  1. Select the breaker, fuse, or switch at the end of the feeder.
  2. Click Fault Bus(es) > Fault Line End.

You can perform line end fault for only one feeder at a time.

More Information

Short Circuit Reference (ANSI)  
Faulting a Bus  
     

www.easypower.com

EasyPower, LLC

7730 SW Mohawk St.

Tualatin, OR 97062

(503)655-5059

techsupport@easypower.com

feedback@easypower.com

EasyPower knowledge base

EasyPower Version 10.0

Copyright © 2018 EasyPower, LLC. All Rights Reserved.

Help was last updated on 5/22/2018