Two Winding Transformer - Location Tab

You can specify the location of the equipment on the floor of a building. You can give the location a name, specify the X and Y coordinates of the location, and select a floor.

The coordinates could be measured in feet, for example, or they could represent points on a grid. There are no units associated with the coordinates, so you can use whatever measurement makes sense for you.

For more information, see Facilities, Floors, and Locations.

The Location tab of the data dialog box is shown.

Figure 1: Location Tab

Option Descriptions
Option Description

Facility

The building in which the equipment is located. Facilities are set up under the Tools > Facilities arrow under Facilities.

Location

The location of the equipment. This is the combination of the Ref 1 and Ref 2 boxes set up on the location. Locations are set up under the Tools > Facilities arrow under Locations.

Description

This is a description of the location. The default description comes from the location, but you can change it. You can type up to 32 characters.

X

This is a numeric value (such as feet or grid locations) that represents the horizontal location. The default X value comes from the location, but you can change it.

Y

This is a numeric value (such as feet or grid locations) that represents the vertical location. The default Y value comes from the location, but you can change it.

Floor

Select the floor where the equipment is located. Floors are set up under the Tools > Facilities arrow under Floors.

More Information