Resetting the Text

If you have applied a custom text template to a one-line file and later decide you want to reset them to the system default text, you can import a blank template file to reset the text.

Note: These instructions assume you have not applied any customization to the default TextTemplate.eztxt file. Normally, this file does not contain any customization.

To reset the text, do the following:

1. Click Tools > Options > One-line Text.



Figure 1: One-line Text Tab

2. Click Import from File.
3. You will receive a warning that all text formats will be replaced. Click OK.



Figure 2: Import Text Warning

4. Browse to the location of the TextTemplate.eztxt file, and then click Open. Typically, this is in your C:\Users\{username}\Documents\EasyPower 10.0\Templates folder.



Figure 3: Select the Default Text Template File

Note: If your TextTemplate.eztxt file has been customized, you can find an non-customized version in C:\ProgramData\EasyPower\EasyPower\10.0\Templates. You may need to adjust your Windows settings to access this folder.

5. The default one-line text is reset. Click Apply to see the change on your one-line, and then click OK to save your changes.
6. Click Save to save the changes to the one-line.

More Information

	www.easypower.com EasyPower, LLC 7730 SW Mohawk St. Tualatin, OR 97062 (503)655-5059	techsupport@easypower.com feedback@easypower.com EasyPower knowledge base EasyPower Version 10.0 Copyright © 2018 EasyPower, LLC. All Rights Reserved. Help was last updated on 5/22/2018