Panel - Location Tab

You can specify the location of the equipment on the floor of a building. You can give the location a name, specify the X and Y coordinates of the location, and select a floor.

The coordinates could be measured in feet, for example, or they could represent points on a grid. There are no units associated with the coordinates, so you can use whatever measurement makes sense for you.

For more information, see Facilities, Floors, and Locations.

Figure 1: Location Tab

Option Descriptions
Option Description

Facility

The building in which the equipment is located. Facilities are set up under the Tools > Options arrow under Facilities.

Location

The location of the equipment. This is the combination of the Ref 1 and Ref 2 boxes set up on the location. Locations are set up under the Tools > Options arrow under Locations.

Description

This is a description of the location. The default description comes from the location, but you can change it. You can type up to 32 characters.

X

This is a numeric value (such as feet or grid locations) that represents the horizontal location. The default X value comes from the location, but you can change it.

Y

This is a numeric value (such as feet or grid locations) that represents the vertical location. The default Y value comes from the location, but you can change it.

Floor

Select the floor where the equipment is located. Floors are set up under the Tools > Options arrow under Floors.

More Information